Visit Rotoplas Booth 323
Rotomolding ROI calculator

Rotomolding ROI calculator: what is over-baking costing your plant?

How much gas, oven time and scrap can you win back?

Enter a few numbers about your ovens, cycle time and gas bill. See the oven time, gas, scrap and operator time RotoSight and PiatIQ could give back, in about a minute.

Your rotomolding plant

Rough numbers are fine. You can change any of them.

Ovens & time
Oven in use is the share of scheduled time the ovens are actually heating molds. Most plants guess high; 60–80% is typical.
Gas & quality
People
Improvement assumptions

Typical results we expect. Change them if your plant is different.

The maths

How do we calculate the estimate?

No black box. Every figure above comes from these four lines, using the numbers you entered.

  1. 1
    Oven time

  2. 2
    Gas

  3. 3
    Scrap

  4. 4
    Operators

In plain words

What is over-baking?

Leaving a mold in the oven longer than the part needs. Nobody can see the air temperature inside the mold, so the oven runs on a timer and a safe margin, and that margin burns gas and oven hours in every cycle. Watch what happens.

Today: the oven runs on a timerWith RotoSight and PiatIQ
Air temperature in the moldTimeTarget air temperatureOver-bakedgas burnedfor nothingSavedgas andoven timePart is readyTimer endsHeating stops
  1. 1The mold goes into the oven. Nobody can see the air temperature inside it, so the cycle is set by habit.
  2. 2The part is already done. It has reached the target air temperature.
  3. 3But the timer has not ended. The oven keeps burning gas and the part keeps baking until the timer says stop.
  4. 4With RotoSight and PiatIQ you see the air temperature live and stop heating at the right moment. The gas and oven hours in the green area are saved.
Gas burned for nothingEvery extra minute at full heat is gas you pay for and the part does not need.
Oven hours you cannot useA shorter cycle frees the oven for more cycles a month, on the same machine.
Parts baked too longToo much heat can leave parts brittle or discoloured, and some end up as scrap.

With the numbers you entered above, stopping on time is worth $0 a year.

Change your numbers
Questions

Questions about the estimate

Short answers about the numbers.

What is over-baking in rotomolding?

Over-baking is leaving a mold in the oven longer than the part needs. When nobody measures the air temperature inside the mold, oven time is set by habit and a safe margin, which costs gas, oven hours and sometimes part quality.

How accurate is the rotomolding ROI estimate?

It is an estimate based on the numbers you enter and typical improvement percentages, which you can change. It is not a quote or a promise. The real figure comes from a diagnostic on your own ovens.

Your estimate

Turn this estimate into a real number on your own ovens.